Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › ECM
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297474 ECM A

FA20 ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89667 1.INSTALL ECM BRACKET

a.

Engage the 2 claws, and install a new ECM bracket to the ECM.

NOTICE:
·

After attaching the ECM bracket to the ECM, do not remove the ECM bracket.

·

If the ECM bracket is attached to the ECM in the incorrect direction, replace the ECM bracket with a new one.




Hide 89661 2.INSTALL ECM

NOTICE:

When replacing the ECM, do not use ECM with different specifications.


a.

Install the ECM with the 2 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the 4 connectors to the ECM.

NOTICE:

Be sure to securely connect the connectors.



Hide 85900 3.INSTALL CONTROL UNIT RELAY ASSEMBLY (w/o Entry and Start System)

Hide 55550 4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55317A 5.INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

Hide 55317A 6.INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL