Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297477 CAMSHAFT POSITION SENSOR A

FA20 ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL VVT SENSOR (for Exhaust Side of Bank 2)

a.

Apply a light coat of engine oil to the new O-ring of the VVT sensor.


b.

Install the VVT sensor with the bolt.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


c.

Connect the VVT sensor connector.


Hide 11102A 3.INSTALL VVT SENSOR (for Intake Side of Bank 2)

a.

Apply a light coat of engine oil to the new O-ring of the VVT sensor.


b.

Install the VVT sensor with the bolt.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


c.

Connect the VVT sensor connector


Hide 11102A 4.INSTALL VVT SENSOR (for Exhaust Side of Bank 1)

a.

Apply a light coat of engine oil to the new O-ring of the VVT sensor.


b.

Install the VVT sensor with the bolt.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


c.

Connect the VVT sensor connector.


Hide 11102A 5.INSTALL VVT SENSOR (for Intake Side of Bank 1)

a.

Apply a light coat of engine oil to the new O-ring of the VVT sensor.


b.

Install the VVT sensor with the bolt.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


c.

Connect the VVT sensor connector.


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL