1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11102A
2.REMOVE VVT SENSOR (for Intake Side of Bank 1)
Disconnect the VVT sensor connector.
Remove the bolt and VVT sensor.
Remove the O-ring from the VVT sensor.
11102A
3.REMOVE VVT SENSOR (for Exhaust Side of Bank 1)
Disconnect the VVT sensor connector.
Remove the bolt and VVT sensor.
Remove the O-ring from the VVT sensor.
11102A
4.REMOVE VVT SENSOR (for Intake Side of Bank 2)
Disconnect the VVT sensor connector.
Remove the bolt and VVT sensor.
Remove the O-ring from the VVT sensor.
51441
5.REMOVE NO. 1 ENGINE UNDER COVER
11102A
6.REMOVE VVT SENSOR (for Exhaust Side of Bank 2)
Disconnect the VVT sensor connector.
Remove the bolt and VVT sensor.
Remove the O-ring from the VVT sensor.