Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297480 ENGINE COOLANT TEMPERATURE SENSOR A

FA20 ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected a strong impact, replace it.

·

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.

Connect the engine coolant temperature sensor connector.