Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › INTAKE MANIFOLD › 2012.03–2016.06
RM2090E _51 Engine / Hybrid System _060669 FA20 INTAKE / EXHAUST _0297515 INTAKE MANIFOLD A

FA20 INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install the 2 new gaskets to the intake manifold.


b.

Install the intake manifold with the 6 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


c.

Engage the 2 clamps and 4 connectors, and connect the wire harness.


d.

Connect the fuel pump connector.


e.

Engage the clamp and connect the engine wire harness.


f.

Engage the 5 clamps and connect the battery cable.


g.

Connect the purge valve connector.


h.

Connect the manifold absolute pressure sensor connector.


Hide 12261 2.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose.


Hide 44771 3.CONNECT VACUUM TUBE CONNECTOR HOSE (for Manual Transmission)

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Air Conditioning System)

a.

Engage the 3 claws and install the No. 1 engine cover sub-assembly.


Hide 23807 5.CONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY

a.

Connect the No. 2 fuel vapor feed hose.


b.

Install the bolt and connect the fuel delivery pipe sub-assembly.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


Hide 22030 11.CONNECT THROTTLE WITH MOTOR BODY ASSEMBLY

a.

Install a new gasket to the intake manifold.


b.

Install the throttle with motor body assembly to intake manifold with the 4 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 12.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 14.INSPECT FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK

Hide 22030 15.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY