Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › VACUUM SENSOR › 2012.03–2016.06
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297483 VACUUM SENSOR A

FA20 ENGINE CONTROL  VACUUM SENSOR  INSTALLATION  


PROCEDURE

Hide 89420M 1.INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Apply a light coat of engine oil to a new O-ring and install it to the manifold absolute pressure sensor.


b.

Install the manifold absolute pressure sensor with the bolt.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the manifold absolute pressure sensor connector.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Air Conditioning System)

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL