Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297484 AIR FUEL RATIO SENSOR A

FA20 ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467A 1.INSTALL AIR FUEL RATIO SENSOR

a.
A276543E02
2.813,1.052 3.042,0.49 true 2.938,0.313 3.229,0.49 0.292,0.177 10 false SST

Using SST, install the air fuel ratio sensor onto the exhaust manifold.

SST
09224-00010  

Torque:
Without SST : 21 N*m (214 kgf*cm, 16 ft.*lbf)
With SST : 18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.


HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.087 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




b.

Engage the 2 clamps.


c.

Connect the air fuel ratio sensor connector.


Hide 2. CONNECT BATTERY NEGATIVE TERMINAL