Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297485 HEATED OXYGEN SENSOR A

FA20 ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL HEATED OXYGEN SENSOR

a.
A276547E05
1.604,1.302 2.052,1.406 true 2.115,1.344 2.406,1.521 0.292,0.177 10 false SST

Using SST, install the heated oxygen sensor onto the exhaust manifold assembly.

SST
09224-00010  

Torque:
without SST : 21 N*m (214 kgf*cm, 16 ft.*lbf)
with SST : 18 N*m (184 kgf*cm, 13 ft.*lbf)

HINT:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.087 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)




b.

Engage the 2 clamps.


c.

Connect the oxygen sensor connector.


Hide 51443C 3.INSTALL REAR ENGINE UNDER COVER RH

a.

Instal the 3 clips, and connect the engine under cover rear RH.


b.

Install the brake hose bracket mounting bolt.


Hide 5.INSTALL FRONT TIRE