Home › Engine / Hybrid System › FA20 (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM2090E _51 Engine / Hybrid System _060666 FA20 ENGINE MECHANICAL _0297493 FRONT CRANKSHAFT OIL SEAL A

FA20 ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16361A 1.REMOVE FAN AND GENERATOR V BELT

Hide 13471 2.REMOVE CRANKSHAFT PULLEY

a.
A302560E01
1.811,3.801 2.581,3.88 false 0.949,2.99 1.893,3.091 false 2.605,3.789 2.804,3.962 0.198,0.172 10 *1 0.747,2.891 0.945,3.064 0.198,0.172 10 *1 0.992,2.211 1.151,1.832 false 0.81,2.218 1.148,2.390 0.338,0.172 10 SST 0.734,4.015 0.99,3.913 false 0.376,3.953 0.714,4.125 0.338,0.172 10 SST

Install SST to the crankshaft pulley.

SST
09213-80010  (90179-10016, 09213-08010, 09213-08110)

HINT:

Position the projections on SST in the direction as shown in the illustration to prevent SST from separating from the crankshaft pulley.


Text in Illustration
*1 Claw


b.
A302561E01
3.046,0.96 3.248,1.136 0.201,0.177 10 *b 1.646,1.905 1.847,2.082 0.201,0.177 10 *a 1.087,1.748 1.22,1.445 false 0.878,1.762 1.227,1.938 0.349,0.177 10 SST

Using SST, hold the crankshaft pulley and loosen the crankshaft pulley set bolt.

SST
09213-80010  (90179-10016, 09213-08010, 09213-08110)

Text in Illustration
*a Hold
*b Turn


c.

Remove the crankshaft pulley.


d.
A276039

Remove the O-ring and crankshaft pulley spacer.


Hide 11302A 3.REMOVE TIMING CHAIN OR BELT COVER OIL SEAL

A276038E01
1.876,1.113 1.053,1.698 false 0.834,1.639 1.004,1.810 0.171,0.171 10 *1

a.

Using a screwdriver with its tip wrapped in protective tape, pry out the timing chain or belt cover oil seal.

Text in Illustration
*1 Protective Tape

NOTICE:

After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.