1.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
Apply a light coat of gasoline to new 2 O-rings, and install the 2 O-rings and backup ring to the fuel pressure regulator assembly.
| *1 | O-Ring |
| *2 | Backup Ring |
Install the fuel pressure regulator assembly to the fuel filter.
2.INSTALL FUEL PUMP ASSEMBLY
Install the new O-ring and fuel pump spacer to the fuel pump assembly.
| *1 | Fuel Pump Wire harness |
| *2 | O-Ring |
| *3 | Fuel Pump Spacer |
Connect the new fuel pump wire harness to the fuel pump assembly.
Apply a light coat of gasoline to a seal, and install it to the fuel pump assembly.
Attach the 5 claws of the fuel filter to install the fuel pump assembly.
When installing the seal, make sure that it does not become pinched or cut.
3.INSTALL NO. 1 FUEL SUB-TANK
Set the fuel suction plate sub-assembly to the No. 1 fuel sub-tank using the spring.
Apply a light coat of gasoline to a new O-ring and install the O-ring to the jet pump.
| *1 | Jet Pump |
Install the jet pump to the No. 1 fuel sub-tank.
When installing the O-ring, make sure that it does not become pinched or cut.
Securely attach the claws.
Attach the 3 claws to install the fuel filter assembly to the No. 1 fuel sub-tank.
Attach the claw to install the jet pump nozzle to the No. 1 fuel sub-tank.
Install a new E-ring.
Connect the connector.
83320
4.INSTALL FUEL SENDER GAGE ASSEMBLY