12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
for Resin Intake Manifold:
(See page Engine / Hybrid System>FA20 INTAKE / EXHAUST>INTAKE MANIFOLD>REMOVAL)
17650
2.REMOVE PURGE VALVE
Remove the nut which holds the purge valve onto the intake manifold.
| *A | for Resin Intake Manifold |
| *B | for Aluminum Intake Manifold |
Disconnect the purge valve connector.
for Resin Intake Manifold
Disconnect the manifold absolute pressure sensor connector.
| *1 | air pressure sensor assembly connector |
| *2 | No. 2 ventilation hose |
Disconnect the No. 2 ventilation hose.
Disconnect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose, and remove the purge valve with the joint wire harness.
| *A | for Resin Intake Manifold |
| *B | for Aluminum Intake Manifold |
| *1 | No. 1 fuel vapor feed hose |
| *2 | No. 2 fuel vapor feed hose |
Remove the joint wire harness from the purge valve assembly.
| *A | for Resin Intake Manifold |
| *B | for Aluminum Intake Manifold |