16331A
1.INSTALL THERMOSTAT
Install a new gasket to the thermostat.
Install the thermostat to the water inlet housing as shown in the illustration.
| *1 | Jiggle Valve |
|
Upper Side |
The jiggle valve must be set within 10° on either side of the position shown in the illustration.
16323
2.CONNECT WATER INLET HOUSING
Install the water inlet housing with the 2 bolts.
3.CONNECT WATER HOSE
Connect the water hose to the water inlet housing with the hose clamp.
4.ADD COOLANT
5.INSPECT FOR COOLANT LEAK
6.INSTALL INTAKE MANIFOLD