28100
1.INSTALL STARTER ASSEMBLY
Temporarily install the upper side bolts.
Install the lower side bolt.
Connect the ground cable with the bolt.
Hold the battery cable stay when tightening the bolt.
Using SST, install the upper side bolt and starter assembly.
Use a torque wrench with a fulcrum length of 260 mm (10.2 in.). When using a torque wrench with a fulcrum length that is not 260 mm (10.24 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
Engage the wire clamp.
Connect the starter connector.
Connect the starter wire with the nut.
17410
2.INSTALL FRONT EXHAUST PIPE ASSEMBLY
51442E
3.INSTALL NO. 2 ENGINE UNDER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL