Home › Engine / Hybrid System › FA20 STARTING › STARTER(for Manual Transmission)
RM2090E _51 Engine / Hybrid System _060672 FA20 STARTING _0297539 STARTER(for Manual Transmission) A

FA20 STARTING  STARTER(for Manual Transmission)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.
A280967

Temporarily install the upper side bolts.


b.
A277913

Install the lower side bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the ground cable with the bolt.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)

NOTICE:

Hold the battery cable stay when tightening the bolt.



d.
A282904E02
0.531,0.313 1.583,1.521 true 0.302,0.146 0.594,0.323 0.292,0.177 10 false SST

Using SST, install the upper side bolt and starter assembly.

SST
09249-37010  

Torque:
without SST : 50 N*m (510 kgf*cm, 37 ft.*lbf)
with SST : 36 N*m (367 kgf*cm, 27 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 260 mm (10.2 in.). When using a torque wrench with a fulcrum length that is not 260 mm (10.24 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




e.

Engage the wire clamp.


f.

Connect the starter connector.


g.

Connect the starter wire with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL