Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297546 PARK / NEUTRAL POSITION SWITCH A

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Clean the bolt and the bolt hole.


b.
A057108E68
2.156,0.26 2.031,0.26 2.031,0.26 1.75,1.292 false 2.198,0.156 2.375,0.323 0.177,0.167 10 false *1

Apply adhesive to 2 or 3 threads on the end of the bolt.

Text in Illustration
*1 Adhesive

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



c.

Temporarily install the park/neutral position switch assembly with the bolt.

HINT:

Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.



d.

Install a new lock washer and the nut to the park/neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


e.

Temporarily install the transmission control shaft lever RH.


f.
C116831E01
1.866,0.104 2.035,0.265 0.170,0.161 10 N 1.573,0.13 1.743,0.290 0.170,0.161 10 R 1.152,0.226 1.322,0.387 0.170,0.161 10 P

Turn the transmission control shaft lever RH counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.


g.

Remove the transmission control shaft lever RH.


h.
U118093E19
1.969,0.896 2.813,0.896 true 1.99,1.563 2.802,1.563 true 1.969,0.563 1.969,1.188 false 2.833,0.802 3,0.958 0.167,0.156 10 false *a 2.833,1.458 3,1.615 0.167,0.156 10 false *b

Align the neutral basic line with the groove as shown in the illustration, and tighten the bolt.

Text in Illustration
*a Neutral Basic Line
*b Groove

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


i.

Using a screwdriver, bend the tabs of the lock washer.


j.

Connect the park/neutral position switch connector.


Hide 35572 2.INSTALL TRANSMISSION CONTROL SHAFT LEVER RH

a.

Install the transmission control shaft lever RH with the spring washer and nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)


Hide 33702B 3.CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

a.

Apply MP grease to the pin.


b.

Install the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the spacer, pin and clip.

HINT:

Install the pin from the right side of the vehicle.



Hide 17410 4.INSTALL FRONT EXHAUST PIPE ASSEMBLY