Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297546 PARK / NEUTRAL POSITION SWITCH A

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17410 2.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 33702B 3.DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

a.
C260576

Remove the clip and pin the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.


Hide 35572 4.REMOVE TRANSMISSION CONTROL SHAFT LEVER RH

a.
C260608

Remove the nut, spring washer and the transmission control shaft lever RH.


Hide 84540 5.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Disconnect the park/neutral position switch connector.


b.
C104746

Using a screwdriver, bend the tabs of the lock washer.


c.
C181091

Remove the nut and the lock washer from the park/neutral position switch assembly.


d.
U146951

Remove the bolt and the park/neutral position switch assembly.

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.