Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM D

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  CHECK MODE PROCEDURE  


HINT:

Check mode has a higher sensitivity to malfunctions and can detect malfunction that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.


DTC CHECK (CHECK MODE)


HINT:

GTS only: Compared to the normal mode, the check mode is more sensitive for detecting malfunctions. Furthermore, the same diagnostic items which are detected in the normal mode can also be detected in the check mode.


a.

Procedure for Check Mode using the GTS.

i.

Check the initial conditions.

·

Battery positive voltage 11 V or more

·

Throttle valve fully closed

·

Transmission in the P or N position

·

A/C switch is off



ii.

Turn the ignition switch off.


iii.

Connect the GTS to the DLC3.


iv.

Turn the ignition switch ON and turn the GTS main switch on.


v.

Enter the following menus: Powertrain / ECT / Utility / Check Mode.

NOTICE:

All DTCs and freeze frame data recorded will be erased if: 1) GTS is used to change the ECM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from the on to on (ACC) or turned OFF.



vi.

Start the engine (the MIL goes off after the engine starts).


vii.

Perform "MONITOR DRIVE PATTERN" for the ECT test (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>MONITOR DRIVE PATTERN), or simulate the conditions of the malfunction described by the customer.

NOTICE:

Leave the ignition switch ON until you have checked the DTCs, etc.



viii.

After simulating malfunction conditions, use the GTS diagnosis selector to check the DTCs and freeze frame data, etc.


ix.

When you use GTS: Enter the following menus: Powertrain / ECT / Trouble Codes.


x.

After checking the DTC, inspect the applicable circuit.





DTC CLEAR


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON and turn the GTS main switch on.


c.

When you use GTS: Enter the following menus: Powertrain / ECT / Trouble Codes / Clear.

HINT:

When operating GTS to erase the codes, the DTCs and freeze frame data will be erased. (See the GTS instruction book for operating instructions.)