Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM C

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  U0140  Lost Communication with Body Control Module  U0155  Lost Communication with Instrument Panel Cluster Control Module (Combination Meter)  


DESCRIPTION

The TCM receives and transmits signals from each ECU using CAN communication.

HINT:
·

Problems on the CAN bus (communication line) can be detected from the DLC3 connector (Except when the DLC3 branch line is open).

·

By using the GTS, it is possible to check CAN communication DTC.

·

The DLC3 is connected to the CAN communication line, but the CAN communication is unable to detect problems on the DLC3 branch line.



DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0100
1.

CAN bus is normal.

2.

Signal from the ECM is interrupted.

3.

500 ms, 800 ms, 2000 ms (differs depending on ID)

4.

1-trip detection logic


CAN communication system
U0122
1.

CAN bus is normal.

2.

Signal from the skid control ECU (brake actuator assembly) is interrupted.

3.

800 ms

4.

1-trip detection logic


CAN communication system
U0140
1.

CAN bus is normal.

2.

Signal from the main body ECU (network gateway ECU) is interrupted.

3.

800 ms, 20000 ms (differs depending on ID)

4.

1-trip detection logic


CAN communication system
U0155
1.

CAN bus is normal.

2.

Signal from combination meter assembly is interrupted.

3.

2000 ms

4.

1-trip detection logic


CAN communication system

CAUTION / NOTICE / HINT

NOTICE:

Perform the universal trip to clear permanent DTCs (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).


PROCEDURE

1.CHECK OTHER DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and push the GTS main switch ON.



Result:
Display (DTC output) Proceed to
U0100, U0122, U0140 or U0155 A
U0100, U0122, U0140 or U0155 and P160A B



A

2.CHECK DTC OUTPUT

B

2.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and push the GTS main switch ON.




NEXT