Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM C

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  U0073  Control Module Communication Bus OFF  U0401  Invalid Data Received from ECM/PCM "A"  U0416  Invalid Data Received from Vehicle Dynamics Control Module  U0422  Invalid Data Received from Body Control Module  U0423  Invalid Data Received from Instrument Panel Cluster Control Module  


DESCRIPTION

HINT:
·

Problems on the CAN bus (communication line) can be detected from the DLC3 connector (Except when the DLC3 branch line is open).

·

By using the GTS, it is possible to check CAN communication DTC.

·

The DLC3 is connected to the CAN communication line, but the CAN communication is unable to detect problems on the DLC3 branch line.



DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
U0073
1.

Ignition voltage is 9 V or more, and this condition continues for 1 second or more.

2.

Data reception and transmission are not possible

3.

500 ms

4.

1-trip detection logic


CAN communication system
U0401
1.

CAN bus is normal.

2.

Reception of malfunction signal from the ECM.

3.

50 times

4.

1-trip detection logic


CAN communication system
U0416
1.

CAN bus is normal.

2.

Reception of malfunction signal from the skid control ECU (brake actuator assembly).

3.

40 times

4.

1-trip detection logic


CAN communication system
U0422
1.

CAN bus is normal.

2.

Reception of malfunction signal from the main body ECU (network gateway ECU).

3.

40 times

4.

1-trip detection logic


CAN communication system
U0423
1.

CAN bus is normal.

2.

Reception of malfunction signal from the combination meter assembly.

3.

40 times

4.

1-trip detection logic


CAN communication system

CAUTION / NOTICE / HINT

NOTICE:

Perform the universal trip to clear permanent DTCs (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and push the GTS main switch ON.




NEXT