This compares values calculated by the TCM with the data stored within the TCM when the ignition switch is turned to ON, and if these do not match 2 times in series, then prohibits learning. If this continues further, power is cut to all solenoids (fixed to 4th).
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P0601 | 1.
Ignition switch is turned to ON 2.
TCM internal malfunction 3.
- 4.
1-trip detection logic |
TCM |
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.
Perform the universal trip to clear permanent DTCs (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).
There is a possibility that the DTC P062F is issued from the ECUs of the ECM and TCM. Use GTS to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.
Replace the TCM (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>TCM>REMOVAL).
NEXT
(See pageDrivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION)