When the ignition switch is turned from off to ON, the TCM calculates the integrated values within the TCM, and if these do not match the values stored within the TCM, the DTC is stored.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P062F | 1.
Ignition switch is turned to ON 2.
TCM internal error 3.
- 4.
1-trip detection logic |
TCM |
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.
Perform the universal trip to clear permanent DTCs (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).
There is a possibility that the DTC P062F is issued from the ECUs of the TCM. Use GTS to conduct a health check to confirm which ECU the DTC is issued from and then inspect the related system.
Replace the TCM (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>TCM>REMOVAL).
NEXT
(See pageDrivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION)