35301A
1.INSTALL FRONT OIL PUMP OIL SEAL
Using SST and a hammer, install a new front oil pump oil seal.
-0.2 to 0.2 mm (-0.00787 to 0.00787 in.)
Coat the lip of the front oil pump oil seal with MP grease.
35301
2.FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
Place the front oil pump body sub-assembly on the torque converter assembly.
35617
3.INSTALL CLUTCH DRUM OIL SEAL RING
Coat 3 new clutch drum oil seal rings with ATF.
Squeeze the ends of the 3 clutch drum oil seal rings so that the gap distance becomes 8 mm (0.315 in.) or less, and then install them to the stator shaft groove.
Do not expand the ring ends excessively.
After installing the clutch drum oil seal rings, check that they rotate smoothly.
4.INSPECT OIL PUMP DRIVE GEAR ROTATION
35301B
5.INSTALL FRONT OIL PUMP BODY O-RING
Coat a new front oil pump body O-ring with ATF and install it to the oil pump assembly.