Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for RHD)
RM2090E _52 Drivetrain _060675 CLUTCH _0297563 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  INSTALLATION  


PROCEDURE

Hide 31481 1.INSTALL CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.

Install the master cylinder to release cylinder hose to the clutch flexible hose bracket with the clip.


b.

Using a union nut wrench (10 mm), connect the clutch master cylinder to flexible hose tube to the master cylinder to release cylinder hose.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Using a union nut wrench (10 mm), connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)



Hide 31410 2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install the sheet to the clutch master cylinder assembly.


b.

Install the clutch master cylinder assembly with the 2 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


c.

Install the master cylinder to release cylinder hose with a union bolt and 2 new gaskets.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 3.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Apply MP grease to the new clevis pin.


b.

Install the clutch master cylinder push rod clevis to the clutch pedal sub-assembly with the clevis pin and a clip.

HINT:

Install the clevis pin from the right side of the vehicle.



Hide 6.INSPECT FOR CLUTCH FLUID LEAK

Hide 8.INSPECT AND ADJUST CLUTCH PEDAL

Hide 73900 9.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY