Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › NEUTRAL POSITION SWITCH
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297571 NEUTRAL POSITION SWITCH A

TL70 MANUAL TRANSMISSION / TRANSAXLE  NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NEUTRAL POSITION SWITCH ASSEMBLY

a.

Using a 19 mm union nut wrench, install the neutral position switch assembly with a new gasket to the manual transmission assembly.

Torque:
32 N*m (329 kgf*cm, 24 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



b.
C262074E02
0.688,1.375 0.792,1.531 0.104,0.156 10 true 1 1.979,1.292 2.083,1.448 0.104,0.156 10 true 2 3.094,0.698 3.198,0.854 0.104,0.156 10 true 3

In the order indicated in the illustration, engage the 3 clamps in place, and connect the back-up light switch assembly wire and neutral position switch assembly wire.

HINT:

Install the wire harness so that there is slack on the connector side.