Home › Drivetrain › TL70 (MANUAL TRANSMISSION / TRANSAXLE) › BACK-UP LIGHT SWITCH
RM2090E _52 Drivetrain _060676 TL70 MANUAL TRANSMISSION / TRANSAXLE _0297572 BACK-UP LIGHT SWITCH A

TL70 MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84210 1.INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

a.

Using a 19 mm union nut wrench, install the back-up light switch assembly with a new gasket to the manual transmission assembly.

Torque:
32 N*m (329 kgf*cm, 24 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



b.
C266431E01
0.472,1.656 0.595,1.827 0.123,0.171 10 1 2.152,1.571 2.275,1.742 0.123,0.171 10 2 2.89,1.142 3.013,1.313 0.123,0.171 10 3

In the order indicated in the illustration, engage the 3 clamps in place, and connect the back-up light switch assembly wire and neutral position switch assembly wire.

HINT:

Install the wire harness so that there is slack on the connector side.