Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY
RM2090E _52 Drivetrain _060677 DRIVE SHAFT / PROPELLER SHAFT _0297580 REAR DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  REMOVAL  


PROCEDURE

Hide 41101 1.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Hide 42312B 2.REMOVE REAR AXLE SHAFT NUT LH

Hide 42340B 3.REMOVE REAR DRIVE SHAFT ASSEMBLY LH

a.
C261034

Using a plastic hammer, separate the rear drive shaft assembly LH from the rear axle carrier. If it is difficult to separate, tap the end of the rear drive shaft assembly LH using a brass bar and a hammer.


b.

Remove the rear drive shaft assembly LH.

NOTICE:
·

Be careful not to damage the joint boot or speed sensor.

·

Do not push out the rear axle carrier excessively.




Hide 42311N 4.REMOVE REAR AXLE SHAFT NUT RH

HINT:

Use the same procedure described for the LH side.


Hide 42330 5.REMOVE REAR DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.