Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297594 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN DIFFERENTIAL OIL

a.
C256680

Using a hexagon wrench 10 mm, remove the rear differential filler plug and gasket.


b.
C256681

Using a hexagon wrench 10 mm, remove the rear differential drain plug and gasket to drain the differential oil.


Hide 37100 3.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 41110 4.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

a.
C256678

Support the rear differential carrier assembly with a transmission jack.


b.
C256679

Remove the 5 bolts, rear upper differential mount stopper and rear lower differential mount stopper.


c.

Lower the transmission jack slowly.


d.
C257535

Using a SST, disconnect the rear drive shaft assembly from the rear differential carrier assembly as shown in the illustration.

SST
09520-01010  
09520-24010  (09520-32040)


e.
C262320

Lower the transmission jack and pull off the rear drive shaft assembly from the rear differential carrier assembly, and then remove the rear differential carrier assembly.

HINT:
C262321

Tie the disconnected rear drive shaft with a rope.