Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM2090E _52 Drivetrain _060677 DRIVE SHAFT / PROPELLER SHAFT _0297582 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 37100 1.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

a.

Completely remove any oil or the like and clean the contact surfaces of the propeller shaft assembly and the rear drive pinion companion flange.


b.

Remove SST from the extension housing. (for Manual Transmission)

SST
09325-20010  


c.

Remove SST from the extension housing. (for Automatic Transmission)

SST
09325-40010  


d.

Insert the front propeller shaft assembly into the extension housing.

NOTICE:

Be careful not to damage the oil seal.



e.

Install the 2 center support bearing washers and the center support bearing.


f.
C256682

Install the 2 bolts and the center support bearing bracket.

Torque:
52 N*m (530 kgf*cm, 38 ft.*lbf)


g.
C256683E02
1.49,1.531 0.938,1.823 true 0.75,1.729 0.906,1.875 0.156,0.146 10 false *a

Align the matchmarks on the differential companion flange and the flexible coupling and connect the propeller shaft.

Text in Illustration
*a Matchmark


h.

Install the rear propeller shaft assembly with the 4 new bolts, 4 washers and 4 new nuts.

NOTICE:

Hold the nut and tighten the bolt.


Torque:
74 N*m (755 kgf*cm, 55 ft.*lbf)


Hide 17420 2.INSTALL CENTER EXHAUST PIPE ASSEMBLY