17420
1.REMOVE CENTER EXHAUST PIPE ASSEMBLY
37100
2.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Place matchmarks on the differential companion flange and flexible coupling.
| *a | Matchmark |
Remove the 4 nuts, 4 bolts and 4 washers.
Remove the 2 bolts.
Disconnect the center support bearing.
Remove the front propeller shaft with the center bearing assembly.
Insert SST in the transmission to prevent oil leaks. (for Manual Transmission)
Be careful not to damage the oil seal.
Insert SST in the transmission to prevent oil leaks. (for Automatic Transmission)
Be careful not to damage the oil seal.