Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297585 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 47710A 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C257546

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum looseness:

0.05 mm (0.00196 in.)


NOTICE:

If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
C257547

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

Maximum runout:

0.05 mm (0.00196 in.)


NOTICE:

If the looseness is more than the maximum, replace the front axle hub and bearing assembly.



Hide 47710A 7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 8.INSTALL FRONT WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)