Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297588 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 47810A 2.SEPARATE REAR CALIPER ASSEMBLY

Hide 4.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C259946

Using a dial indicator, check for looseness near the center of the rear axle hub.

Maximum looseness:

0.05 mm (0.00196 in.)


NOTICE:
·

Make sure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 5.INSPECT REAR AXLE HUB RUNOUT

a.
C259947

Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

Maximum runout:

0.05 mm (0.00196 in.)


NOTICE:
·

Make sure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



If the runout is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 47810A 7.INSTALL REAR CALIPER ASSEMBLY

Hide 8.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)