Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297594 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Support the rear differential carrier assembly using a jack.


b.

Install a new snap ring to the rear drive shaft assembly.


c.

Coat the spline of the inboard joint shaft assembly with toyota genuine differential gear oil LT.


d.

Install the shaft snap ring with the opening facing downward.


e.

Align the shaft splines and install the drive shaft assembly with a brass bar and hammer.

NOTICE:
·

Be careful not to damage the drive shaft dust cover, boot or oil seal.

·

Keep the drive shaft assembly level while handling it.

·

Do not tap the axle side of the drive shaft with the hammer.

·

Set the hole snap ring with the opening facing down word.



HINT:

Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when tapping it in.



f.

Install the rear differential mount stopper upper and rear differential mount stopper lower to the rear differential carrier assembly.


g.
C453739E01
2.219,3.333 0.635,3.396 0.635,3.396 2.177,3.177 true 0.823,0.542 0.979,0.74 0.156,0.198 10 true A 0.531,1.094 0.688,1.292 0.156,0.198 10 true A 0.177,1.26 0.333,1.458 0.156,0.198 10 true A 2.281,1.99 2.438,2.188 0.156,0.198 10 true B 3.104,1.469 3.26,1.667 0.156,0.198 10 true B 0.365,3.333 0.677,3.531 0.313,0.198 10 false *a

Temporarily tighten the 5 bolts to install the rear differential carrier assembly along with the rear upper differential mount stopper and the rear lower differential mount stopper.


h.

Fully tighten the 3 bolts (A).

Torque:
62 N*m (632 kgf*cm, 46 ft.*lbf)


i.

Put matchmarks on the rear lower differential mount stopper and rear differential carrier assembly.

Text in Illustration
*a Matchmark


j.

Fully tighten the 2 bolts (B) in 3 steps so the matchmarks stay aligned.

Torque:
1st : 30 N*m (306 kgf*cm, 22 ft.*lbf)
2nd : 60 N*m (612 kgf*cm, 44 ft.*lbf)
3rd : 95 N*m (969 kgf*cm, 70 ft.*lbf)

NOTICE:

If the matchmarks do not align, retighten the bolts starting from the first step.



Hide 37100 2.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Hide 4.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)