The procedure listed below is for the LH side.
Use the same procedure for the RH and LH sides.
1.REMOVE REAR WHEEL
46451C
2.REMOVE NO. 1 PARKING BRAKE CABLE SUPPORT BRACKET
Remove the bolt and No.1 parking brake cable support bracket.
48720A
3.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
Remove the 2 bolts, 2 nuts and the rear No. 1 suspension arm assembly LH.
89408C
4.SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)
48802
5.SEPARATE STABILIZER LINK SUB-ASSEMBLY (for LH Side)
6.SEPARATE REAR SHOCK ABSORBER WITH COIL SPRING
Remove the bolt, nut and separate the rear shock absorber with coil spring from the rear No. 2 suspension arm assembly.
48740F
7.REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
Remove the nut and bolt on the axle carrier side, and then separate the rear No. 2 suspension arm assembly LH.
Remove the bolt and nut on the rear suspension member side, and then remove the rear No. 2 suspension arm assembly LH.