Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2014.05
RM2090E _53 Suspension _060682 TIRE PRESSURE MONITORING _0297611 TIRE PRESSURE WARNING SYSTEM D

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  DIAGNOSIS SYSTEM  


CHECK WARNING LIGHT


NOTICE:
·

When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals, and illuminates after 1 minute.

·

When the malfunction has been corrected, the tire pressure warning light does not illuminate.

·

When the tire pressure warning light illuminates, immediately check the tire pressures of the tire and adjust it to the specified value(s).

·

After the ignition switch is turned to ON, the tire pressure warning light illuminates for 3 seconds and then goes off. If the warning light does not illuminate for 3 seconds, proceed to the troubleshooting for the tire pressure warning light circuit (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>Tire Pressure Warning Light Circuit).



a.

Turn the ignition switch to ON.


b.
C213286E02
0.616,0.112 0.987,0.358 0.371,0.246 10 *1

Check that the tire pressure warning light illuminates for 3 seconds.

Text in Illustration
*1 Tire Pressure Warning Light



WHAT TO CONSIDER WHEN TIRE PRESSURE WARNING LIGHT ILLUMINATES


a.

When the tire pressure warning light does not go off, or when it illuminates during driving, check the tire pressure. If the tire pressure warning light illuminates within several hours after adjusting the tire pressure, the tire may have a slow air leak.


b.

The system is disabled in the following conditions (when the condition becomes normal, the system will work properly).

i.

When all of the tires and wheels that have the tire pressure warning valve and transmitters registered with the tire pressure warning ECU and receiver have not been installed.


ii.

When all of the transmitter ID codes are not registered with the tire pressure warning ECU and receiver.


iii.

When the tire pressure is abnormally high (absolute pressure: 480 kPa (4.9 kgf/cm2, 70 psi) or more; relative pressure: 380 kPa (3.9 kgf/cm2, 55 psi) or more).


iv.

When the tire pressure warning valve and transmitter battery is depleted.



c.

The system may become disabled in the following conditions (when the condition becomes normal, the system will work properly).

i.

When electric devices or facilities using similar radio frequencies are nearby.


ii.

When a wireless device or other equipment operating at a similar frequency is in use in the vehicle.


iii.

When a window tint that affects radio wave signals is installed.


iv.

When there is a lot of snow or ice on the vehicle, in particular, around the wheels or wheel housing.


v.

When non-genuine wheels are used.


vi.

When tire chains are used.




TIRE PRESSURE WARNING LIGHT AND INDICATOR CHART


HINT:

The table below indicates the state of the tire pressure warning light after the ignition switch is turned to ON.

Immediately after turning the ignition switch to ON Always
Warning light output pattern
Illuminates for 3 seconds Goes off Illuminates Blinks*1 Blinks*2 Blinks*3 Blinks*4 Outputs DTC
Normal ○ ○ - - - - - -
Low tire pressure ○ - ○ - - - - -
System failure ○ - - ○ - - - -
Test mode (signal check mode) ○ - - - ○ - - -
Initialization ○ - - - - ○ - -
ECU connector poorly connected - - - ○ - - - -
TC grounded (DTC is output) ○ - - - - - - ○
TC grounded (DTC is not output) ○ - - - - - ○ -
ID code being verified ○ - - ○ - - - -


E133091E06
1.011,1.377 1.518,1.531 0.507,0.154 10 *c 1.145,0.312 1.364,0.466 0.220,0.154 10 *c 0.204,0.683 0.453,0.822 0.250,0.139 10 *a 0.204,1.001 0.509,1.140 0.305,0.139 10 *b 1.523,1.783 1.757,1.922 0.235,0.139 10 *d

*1: Illuminates and goes off repeatedly at 0.5 second intervals, and illuminates after 1 minute.

Text in Illustration
*a ON
*b OFF
*c 0.5 seconds
*d 1 minute

C370014E01
0.625,0.49 0.938,0.688 0.313,0.198 10 false *c 0.104,0.833 0.417,1.031 0.313,0.198 10 false *a 0.115,1.135 0.427,1.333 0.313,0.198 10 false *b 0.385,1.49 0.698,1.688 0.313,0.198 10 false *c

*2: Illuminates and goes off repeatedly at 0.125 second intervals.

Text in Illustration
*a ON
*b OFF
*c 0.125 seconds

C110636E11
1.003,0.423 1.407,0.587 0.404,0.164 10 *c 0.745,1.471 1.150,1.635 0.404,0.164 10 *c 0.225,0.814 0.463,0.978 0.238,0.164 10 *a 0.225,1.11 0.525,1.274 0.300,0.164 10 *b

*3: Blinks 3 times (1 second on, 1 second off).

Text in Illustration
*a ON
*b OFF
*c 1 second

C145821E05
1.356,0.494 1.939,0.636 0.583,0.142 10 *c 0.256,0.846 0.484,0.988 0.229,0.142 10 *a 0.256,1.184 0.554,1.326 0.298,0.142 10 *b 1.226,1.541 1.809,1.683 0.583,0.142 10 *c

*4: Illuminates and goes off repeatedly at 0.25 second intervals.

Text in Illustration
*a ON
*b OFF
*c 0.25 seconds



Normal mode DTCs


a.

DTCs are stored in the tire pressure warning ECU and receiver and output by the blinking of tire pressure warning light or by using the GTS (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).



Test mode (signal check mode) DTCs


a.

By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning ECU and receiver, each tire pressure warning valve and transmitter (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>TEST MODE PROCEDURE).



FAIL-SAFE FUNCTION


a.

When a system malfunction occurs in the tire pressure warning system, the tire pressure warning light illuminates after blinking for 1 minute to inform the driver of the system failure.


b.

The result of this diagnosis code is stored in the tire pressure warning ECU and receiver.