After all IDs are registered, DTC C2126/26 is set in the tire pressure warning ECU and receiver and the tire pressure warning light blinks for 1 minute and then illuminates.
When the tire pressure warning ECU and receiver successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is cleared and the tire pressure warning light goes off.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2126/26 | After ID registration is completed, ECU does not receive radio waves from transmitters whose IDs are stored in ECU. | ·
ID registration failure ·
Tire pressure warning valve and transmitter ·
Tire pressure warning ECU and receiver |
The purpose of this DTC is to help prevent delivering a vehicle that has incorrectly registered IDs. After all IDs are registered, DTC C2126/26 is detected and the tire pressure warning light blinks for 1 minute and then illuminates. If the tire pressure warning light does not turn off after a little while, IDs may be incorrectly registered.
Refer to DTC C2111/11 (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2111/11).
When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION ) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.
Set the tire pressure to the specified values (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ID1 Tire Inflation Pressure | ID1 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID2 Tire Inflation Pressure | ID2 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID3 Tire Inflation Pressure | ID3 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID4 Tire Inflation Pressure | ID4 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
*: It may take a few minutes until the values are displayed.
Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.
Check the Data List.
It may take a few minutes to display the updated tire pressure data.
When the "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the data.
Record the "ID Tire Inflation Pressure" data transmitter ID that corresponds to each tire.
After confirming that the "ID Tire Inflation Pressure" data for one tire (ID1 to ID4) has changed, repeat this procedure one by one. Identify the transmitter not received.
| Condition | Proceed to |
|---|---|
| One or more of transmitters abnormal | A |
| All normal | B |
A
B
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Display | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Registered ID1 Code | Registered ID1 code /
min.: 0 max.: FFFFFFF* |
ID No. registered for transmitter ID1 displayed | - |
| Registered ID2 Code | Registered ID2 code /
min.: 0 max.: FFFFFFF* |
ID No. registered for transmitter ID2 displayed | - |
| Registered ID3 Code | Registered ID3 code /
min.: 0 max.: FFFFFFF* |
ID No. registered for transmitter ID3 displayed | - |
| Registered ID4 Code | Registered ID4 code /
min.: 0 max.: FFFFFFF* |
ID No. registered for transmitter ID4 displayed | - |
*: Displayed only when the ID No. is not registered.
Check the ID number on the identified transmitter by removing it from the tire and wheel.
| *1 | Tire pressure warning valve and transmitter | *2 | Transmitter ID (7-digit number) |
Confirm that the ID number on the transmitter and recorded transmitter ID match.
| Result | Proceed to |
|---|---|
| Match | A |
| Do not match | B |
A
B
Replace the tire pressure warning valve and transmitter (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING VALVE>REMOVAL).
NEXT
Perform registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION).
NEXT
Perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).
NEXT
Turn the ignition switch off.
Connect GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ID1 Tire Inflation Pressure | ID1 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID2 Tire Inflation Pressure | ID2 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID3 Tire Inflation Pressure | ID3 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID4 Tire Inflation Pressure | ID4 tire inflation pressure /
min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
*: It may take a few minutes until the values are displayed.
When no "ID Tire Inflation Pressure" data has changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the data.
| Result | Proceed to |
|---|---|
| Tire pressure values are not displayed. | A |
| All tire pressure readings are equal to specified values. | B |
A
B