Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1294  ECT System Malfunction  


DESCRIPTION

If a malfunction in the automatic transmission system is detected, the operation of VSC and TRC is prohibited by the fail-safe function. When the signals from the automatic transmission are received normally, fail-safe control is canceled.

DTC No. DTC Detection Condition Trouble Area
C1201 Automatic transmission system malfunction signal continues for 0.5 seconds. Automatic transmission system

PROCEDURE

1.CHECK AUTOMATIC TRANSMISSION SYSTEM
a.

Check if the automatic transmission system DTC is output (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is not output. A
DTC is output. B


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).




A

B