Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for LHD)
RM2090E _54 Brake _060685 BRAKE SYSTEM (OTHER) _0297631 BRAKE BOOSTER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  REMOVAL  


PROCEDURE

Hide 55318C 1.REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:

Use the same procedure for the LH side as for the RH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL).


Hide 55606 2.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 3.REMOVE LOWER NO. 1 INSTRUMENT FANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 89071B 4.REMOVE TCM (for Automatic Transmission)

Hide 47201 5.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 44771 6.DISCONNECT VACUUM TUBE CONNECTOR HOSE

a.

Slide the clip and disconnect the vacuum tube connector hose from the brake booster assembly.


Hide 47311 7.REMOVE FRONT NO. 1 BRAKE TUBE

a.
C263593

Using a union nut wrench 12 mm, disconnect the front No. 1 brake tube from the brake actuator.


b.
U147177

Disconnect 2 clips and remove the front No. 1 brake tube.


Hide 47312 8.REMOVE FRONT NO. 2 BRAKE TUBE

a.
C263594

Using a union nut wrench 12 mm, disconnect the front No. 2 brake tube from the brake actuator.


b.
U147178

Disconnect 2 clips and remove the front No. 2 brake tube.


Hide 44610 9.REMOVE BRAKE BOOSTER ASSEMBLY

a.

Loosen the push rod clevis lock nut.


b.
C263601

Remove the 4 nuts.


c.
C263602

Remove the push rod clevis pin.


d.

Remove the brake booster assembly.


Hide 10.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Remove the brake master cylinder push rod clevis and lock nut.