Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for Floating Type Caliper)
RM2090E _54 Brake _060686 BRAKE (FRONT) _0297633 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring. If necessary, replace the disc brake cylinder and piston.


Hide 04465 2.CHECK PAD LINING THICKNESS

a.
C256656

Using a ruler, measure the pad lining thickness.

Standard thickness:

11.0 mm (0.4331 in.)


Minimum thickness:

1.5 mm (0.0591 in.)


If the pad lining thickness is lower/under the minimum, replace the pad.


Hide 43512 3.CHECK DISC THICKNESS

a.
C256657

Using a micrometer, measure the disc thickness.

Standard Thickness:

24.0 mm (0.945 in.)


Minimum Thickness:

22.0 mm (0.866 in.)



Hide 4.CHECK DISC RUNOUT

a.
C256653E01
2.646,0.106 2.834,0.272 0.189,0.166 10 *1 2.28,0.198 2.621,0.198 false

Check the bearing play in the axial direction and check the axle hub runout (See page Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION).


b.

Tighten the disc with the 5 nuts.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


c.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.

Text in Illustration
*1 Dial Indicator

Maximum disc runout:

0.05 mm (0.0020 in.)


NOTICE:
·

Do not bring the magnetic base near the axle hub and speed sensor.

·

Set the magnetic base on the shock absorber.

·

If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, replace the front disc.




d.

Remove the 5 hub nuts and front disc.