Home › Brake › BRAKE (REAR) › REAR BRAKE (for Floating Type Caliper)
RM2090E _54 Brake _060687 BRAKE (REAR) _0297635 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C262317

Using a ruler, measure the pad lining thickness.

Specification Minimum Thickness Standard Thickness
Solid Type 1.5 mm (0.059 in.) 9.0 mm (0.354 in.)
Ventilated Type 1.5 mm (0.059 in.) 11.0 mm (0.433 in.)


Hide 42431 3.INSPECT DISC THICKNESS

a.
C256658

Using a micrometer, measure the disc thickness.

Specification Minimum Thickness Standard Thickness
Solid Type 8.5 mm (0.3346 in.) 10.0 mm (0.3937 in.)
Ventilated Type 16.5 mm (0.6496 in.) 18.0 mm (0.7087 in.)


Hide 4.INSPECT DISC RUNOUT

a.
C256654E02
0.375,0.677 0.948,0.813 true 0.188,0.573 0.354,0.74 0.167,0.167 10 false *1

Check the bearing play in the axial direction and check for the axle hub runout (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>ON-VEHICLE INSPECTION).


b.

Tighten the disc with the 5 nuts.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


c.

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.

Text in Illustration
*1 Dial Indicator

Maximum disc runout:

0.05 mm (0.0020 in.)


NOTICE:
·

If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, replace the front disc.




d.

Remove the 5 hub nuts and rear disc.