Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2090E _55 Steering _060689 POWER ASSIST SYSTEMS _0297642 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1515  Torque Sensor Zero Point Adjustment Undone  C1525  Rotation Angle Sensor Initialization Undone  


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration have not been performed.

DTC Code DTC Detection Condition Trouble Area
C1515 Torque sensor zero point calibration has not been performed. There is no malfunction if this DTC is not output again after performing torque sensor zero point calibration.
C1525 Rotation angle sensor value initialization has not been performed. There is no malfunction if this DTC is not output again after performing rotation angle sensor value initialization.

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
a.

Initialize the rotation angle sensor and calibrate the torque sensor zero point (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

NOTICE:

If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.


Result
Condition Proceed to
DTC C1515 or C1525 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times. A
DTC C1515 or C1525 is not output. B



A

3.REPLACE POWER STEERING ECU ASSEMBLY

B

END

3.REPLACE POWER STEERING ECU ASSEMBLY
a.

Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).



NEXT

4.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
4.INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
a.

Initialize the rotation angle sensor and calibrate the torque sensor zero point (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

NOTICE:

If DTC C1515 or C1525 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.


Result
Condition Proceed to
DTC C1515 or C1525 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times. A
DTC C1515 or C1525 is not output. B



A

REPLACE STEERING COLUMN ASSEMBLY

B

END