These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that the rotation angle sensor value initialization and torque sensor zero point calibration are incomplete.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1516 | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration. |
| C1526 | Rotation angle sensor value initialization is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing rotation angle sensor value initialization. |
If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Clear the DTC(s) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
NEXT
Initialize the rotation angle sensor and calibrate the torque sensor zero point (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
If DTC C1516 or C1526 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform the calibration and initialization 3 times.
| Condition | Proceed to |
|---|---|
| DTC C1516 or C1526 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times. | A |
| DTC C1516 or C1526 is not output. | B |
A
B
Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).
NEXT
Clear the DTC(s) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
NEXT
Initialize the rotation angle sensor and calibrate the torque sensor zero point (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
If DTC C1516 or C1526 is output even though the rotation angle sensor value initialization and torque sensor zero point calibration have been performed, check the procedure again, and perform calibration and initialization 3 times.
| Condition | Proceed to |
|---|---|
| DTC C1516 or C1526 is still output after performing rotation angle sensor initialization and torque sensor zero point calibration 3 times. | A |
| DTC C1516 or C1526 is not output. | B |
A
B