Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.04
RM2090E _55 Steering _060689 POWER ASSIST SYSTEMS _0297642 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582  Assist Map Number Mismatch  C1583  Assist Map Selection Error  


DESCRIPTION

If an incorrect power steering ECU assembly or combination meter assembly is installed, DTC C1582 and C1583 is stored as the vehicle specification and data do not match.

HINT:

The assist map is data written in the power steering ECU assembly to control the degree of assistance. The assist map is selected based on the vehicle's specified communication data.


DTC Code DTC Detection Condition Trouble Area
C1582 Data that does not match the vehicle specification is received through CAN communication.
·

CAN communication system

·

Combination meter assembly (wrong assembly)

·

Power steering ECU assembly


C1583 Correct information cannot be received.
·

CAN communication system

·

Combination meter assembly (wrong assembly)

·

Power steering ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
a.

Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

DTC is not output.




OK

2.CHECK COMBINATION METER ASSEMBLY

NG

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK COMBINATION METER ASSEMBLY
a.

Check if a combination meter assembly that complies with the vehicle specifications is installed.



OK

3.CHECK ASSIST MAP

NG

REPLACE COMBINATION METER ASSEMBLY

3.CHECK ASSIST MAP
a.

Check for assist map.

OK:

MAP2 is output.




OK

4.CLEAR ASSIST MAP

NG

4.CLEAR ASSIST MAP
HINT:

Repeat the clear assist map process 2 or 3 times and check the results.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / EMPS / Utility / Assist Map Confirmation / Clear.


e.

Clear the assist map following the instructions on the GTS screen.


f.

Start the engine.

HINT:

If no assist map is currently written, it will be written in the ECU when the engine is started while the vehicle is stationary.



g.

Enter the following menus: Chassis / EMPS / Utility / Assist Map Confirmation / Clear.


h.

Check that "MAP2" is displayed on the GTS screen.

OK:

MAP2 is output.




OK

END

NG

REPLACE POWER STEERING ECU ASSEMBLY