Do not replace the spiral cable with the battery connected and the ignition switch ON.
Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.
45130
4.REMOVE HORN BUTTON ASSEMBLY
45111
5.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly set nut.
| *1 | Matchmark |
Put matchmarks on the steering wheel assembly and steering column assembly.
Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.
Using SST, remove the steering wheel assembly.
| *a | Turn |
| *b | Hold |
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
84610F
6.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for Automatic Transmission)
84630
7.REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY (w/ Cruise Control System)
8.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
45713A
9.REMOVE STEERING SHAKE DAMPER
Remove the 2 screws and steering shake damper from steering wheel assembly.
45184
10.REMOVE LOWER STEERING WHEEL BOSS COVER
Disengage the 4 claws and remove the lower steering wheel boss cover from steering wheel assembly.
45116
11.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 screws.
Disengage the 4 claws to remove the No. 1 steering wheel ornament.