Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
55461A
2.REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)
55405B
3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)
4.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts and pull the radio receiver assembly with bracket toward the rear of the vehicle.
Disconnect each connector and remove the radio receiver assembly with bracket.
86211
5.REMOVE NO. 1 RADIO BRACKET
Remove the 4 screws and remove the No. 1 radio bracket from the radio receiver assembly.
86212
6.REMOVE NO. 2 RADIO BRACKET
Use the same procedure as for the No. 1 radio bracket.