Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) › 2012.03–2014.05
RM2090E _58 Vehicle Interior _060696 DOOR LOCK _0297668 WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) C

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)  B1242  Wireless Door Lock Tuner Circuit Malfunction  


DESCRIPTION

This door control receiver receives signals from the transmitter and sends these signals to the main body ECU (network gateway ECU).

DTC No. DTC Detection Condition Trouble Area
B1242 In diagnostic mode, applicable RDA signal cannot be received 3 times in succession after the PRG signal is output from the main body ECU (network gateway ECU).
·

Wire harness or connector

·

Door control receiver

·

Main body ECU (network gateway ECU)



WIRING DIAGRAM

B222320E15
3.635,0.844 4.698,1.156 1.063,0.313 10 false to Main Fuse 1.844,2.26 2.552,2.479 0.708,0.219 10 false GND 1.844,1.802 2.594,1.969 0.75,0.167 10 false RDA 5.229,1.313 5.813,1.552 0.583,0.24 10 false PRG 1.833,1.344 2.656,1.51 0.823,0.167 10 false PRG 5.229,1.771 5.969,2.031 0.74,0.26 10 false RDA 1.948,0.865 2.5,1.063 0.552,0.198 10 false +B 2.208,0.771 2.333,0.938 0.125,0.167 10 false 5 2.208,1.698 2.365,1.854 0.156,0.156 10 false 2 2.198,1.24 2.354,1.396 0.156,0.156 10 false 3 2.198,2.167 2.354,2.323 0.156,0.156 10 false 1 0.917,2.865 3.198,3.219 2.281,0.354 10 false Door Control Receiver 4.75,2.823 6.792,3.469 2.042,0.646 10 false Main Body ECU (Network Gateway ECU) 5.042,1.708 5.156,1.854 0.115,0.146 10 false 7 5.042,1.229 5.146,1.375 0.104,0.146 10 false 6 2.813,1 3.583,1.229 0.771,0.229 10 false ECU-B 0.917,2.708 1.698,2.875 0.781,0.167 10 false H27 4.76,2.656 5.458,2.813 0.698,0.156 10 false D6

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (NETWORK GATEWAY ECU) - DOOR CONTROL RECEIVER)
a.

Disconnect the D6 main body ECU (network gateway ECU) connector.


b.

Disconnect the H27 door control receiver connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
D6-6 (PRG) - H27-3 (PRG) Always Below 1 Ω
D6-6 (PRG) or H27-3 (PRG) - Body ground Always 10 kΩ or higher
D6-7 (RDA) - H27-2 (RDA) Always Below 1 Ω
D6-7 (RDA) or H27-2 (RDA) - Body ground Always 10 kΩ or higher




OK

2.INSPECT DOOR CONTROL RECEIVER (POWER SOURCE, GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT DOOR CONTROL RECEIVER (POWER SOURCE, GROUND)
a.
U190178E01
0.205,0.157 0.391,0.318 0.186,0.161 10 *a 1.522,0.236 1.817,0.392 0.295,0.156 10 H27 2.137,1.489 2.268,1.907 false 2.186,1.919 2.407,2.075 0.221,0.156 10 +B 1.295,1.489 1.164,1.907 false 0.944,1.919 1.283,2.075 0.340,0.156 10 GND

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H27-5 (+B) - Body ground Always 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
H27-1 (GND) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Door Control Receiver)



OK

3.REPLACE DOOR CONTROL RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE DOOR CONTROL RECEIVER
a.

Temporarily replace the door control receiver with a new or normally functioning one (See page Vehicle Interior>DOOR LOCK>DOOR CONTROL RECEIVER>REMOVAL).



NEXT

4.REGISTER RECOGNITION CODE
4.REGISTER RECOGNITION CODE
a.

Perform the Registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>REGISTRATION).

HINT:

If a new or normal functioning door control receiver is available, connect it and check if the wireless door lock function is normal or the DTC is output. If the alternative receiver functions normally, replace the original door control receiver.




NEXT

5.CLEAR DTC
6.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).

OK:

DTC is not output.


HINT:

Reinstall the parts, such as sensors and connectors, and restore the vehicle to its previous conditions before rechecking for DTCs.




OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU)