Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY(w/o Entry and Start System)
RM2090E _58 Vehicle Interior _060696 DOOR LOCK _0297673 TRANSMITTER BATTERY(w/o Entry and Start System) A

DOOR LOCK  TRANSMITTER BATTERY(w/o Entry and Start System)  REPLACEMENT  


CAUTION / NOTICE / HINT

NOTICE:

Take extra care when handling these precision electronic components.


PROCEDURE

Hide 89071B 2.REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY

Hide 89745A 3.REMOVE TRANSMITTER BATTERY

a.
B250770

Disengage the hook and remove the transmitter battery cover.


b.
B250771

Remove the transmitter battery (lithium battery: CR2016).

NOTICE:
·

Do not push the terminals with your finger.

·

Do not use excessive force when prying up the battery (lithium battery: CR2016) as this may damage the terminals.

·

Do not touch the battery with wet hands. Water may cause it to rust.

·

Do not touch or move any components inside the transmitter as this may interfere with its proper operation.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter from being damaged.



HINT:

Tape the screwdriver tip before use.



Hide 89745A 4.INSTALL TRANSMITTER BATTERY

a.
B250772

Install a battery (lithium battery: CR2016) with the positive (+) side up, as shown in the illustration.

NOTICE:
·

Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.

·

Do not bend the transmitter battery electrode during insertion.

·

Keep the transmitter cover interior free of dust and oil.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter from being damaged.




b.
B250773

Engage the hook and install the transmitter battery cover.

NOTICE:

Securely engage the claws of the cover to prevent the poor contact between the battery and terminal.



Hide 89071B 5.INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY