Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT DOOR LOCK ASSEMBLY
Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wire harness seal.
Apply MP grease to the sliding parts of the front door lock assembly.
Insert the front door lock open rod into the front door lock assembly.
Check that the front door lock open rod is securely connected to the front door lock assembly.
Install the front door lock assembly with the 3 bolts.
69510
2.INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)
67404F
3.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
68102
4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67862
5.INSTALL FRONT DOOR WEATHERSTRIP
67832
6.INSTALL FRONT DOOR SERVICE HOLE COVER
67602
7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
74222
8.INSTALL DOOR ARMREST COVER
9.INSTALL INITIALIZE POWER WINDOW CONTROL SYSTEM
10.INSPECT POWER WINDOW OPERATION