The ECM stores this code if the certification ECU (smart key ECU assembly) reference code and the reference code from the ECM do not match.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B1571 | The ECM reference code and reference code from the certification ECU (smart key ECU assembly) do not match (1 trip detection logic*). | ·
ECM ·
Certification ECU (smart key ECU assembly) |
Engine switch on (IG) |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
|---|---|
| B1571 | - |
Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>PRECAUTION).
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Register the ECU communication ID (Refer to Service Bulletin).
Check that the engine can be started.
The engine can be started.
OK
NG
Temporarily replace the ECM with a new one (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>ECM>REMOVAL).
NEXT
Register the ECU communication ID (Refer to Service Bulletin).
Check that the engine can be started.
The engine can be started.
OK
NG