Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM2090E _58 Vehicle Interior _060701 SUPPLEMENTAL RESTRAINT SYSTEMS _0297704 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1675  Rear Floor Airbag Sensor  B16F8  Rear Floor Airbag Sensor RH Mismatch  


DESCRIPTION

The No. 2 airbag sensor assembly circuit is composed of the airbag ECU assembly and No. 2 airbag sensor assembly.

The No. 2 airbag sensor assembly detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbag should be deployed.

These DTCs are stored when a malfunction is detected in the No. 2 airbag sensor assembly circuit.

DTC Code DTC Detection Condition Trouble Area
B1675
·

No. 2 airbag sensor assembly malfunction.

·

Airbag ECU assembly malfunction.


·

No. 2 airbag sensor assembly

·

Airbag ECU assembly


B16F8
·

Improper installation of No. 2 airbag sensor assembly.

·

Airbag ECU assembly malfunction.



WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


PROCEDURE

1.CHECK NO. 2 AIRBAG SENSOR ASSEMBLY
a.
C238224E05
0.792,1.01 0.938,1.198 0.146,0.188 10 false *1 2.313,1.01 2.521,1.198 0.208,0.188 10 false *2 1.875,1.01 2,1.198 0.125,0.188 10 false A 1.708,1.01 1.833,1.198 0.125,0.188 10 false B 1.271,1.01 1.396,1.198 0.125,0.188 10 false C 1.115,1.01 1.24,1.198 0.125,0.188 10 false D

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Replace the No. 2 airbag sensor assembly with a new one.


d.

Connect the cable to the negative (-) battery terminal.



f.

Turn the ignition switch off.


g.

Turn the ignition switch to ON, and wait for at least 60 seconds.


h.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTCs B1675 and B16F8 are not output. A
DTC B1675 or B16F8 is output. B


HINT:

Codes other than DTC B1675, B16F8 may be output at this time, but they are not related to this check.


Text in Illustration
*1 No. 2 Airbag Sensor Assembly
*2 Airbag ECU Assembly



A

END (NO. 2 AIRBAG SENSOR ASSEMBLY WAS DEFECTIVE)

B