Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM2090E _58 Vehicle Interior _060701 SUPPLEMENTAL RESTRAINT SYSTEMS _0297709 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing. (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 63310 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 62180A 3.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

CAUTION:

When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



c.
B311382E02
0.406,2.094 1.063,2.427 true 0.635,0.26 1.229,0.208 true 0.417,1.573 1.115,1.927 true 0.219,1.99 0.406,2.146 0.188,0.156 10 false *1 0.219,1.479 0.406,1.635 0.188,0.156 10 false *2 1.302,0.125 1.49,0.281 0.188,0.156 10 false *3

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

Text in Illustration
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



d.

Remove the 9 bolts and engage the 9 guides to remove the curtain shield airbag assembly.

B311383

NOTICE:

When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.


HINT:

Remove the bolts and guides in order, from the front.